3 Steps To Start A Fire When Everything Is Wet

Starting a fire in adverse weather, whether is rain or wind or both is a very important survival skill every outdoors aficionado must possess. The ability of igniting a fire when things are less than perfect is a fine art which must be learned and practiced until mastery is achieved.

The thing is, nature doesn’t care much about our best laid plans, mice and men alike and an emergency never comes alone. I mean, when confronted with a survival situation, you’d at least expect fine weather, cool breezes and sunshine.

In reality, your survival in an emergency situation will become much more complicated than initially thought and I would dare to say nine times out of ten, as you’ll end up not only lost in the woods or wherever, but you’ll also have to deal with rain, cold and high winds.

Emergencies almost always bring bad weather with them, it’s almost like a 2 for the price of 1 deal. And that’s fine as long you’re prepared both physically and mentally.

However, in critical times, your survival may depend on your ability to light a fire under rain and/or wind and any hardcore survivalist, even Bear Grylls will tell you that you should always carry at least 2 primary and 2 secondary tools for starting a fire.

The idea is that a regular fire starter may not always provide you with the best results, especially if it’s raining and it gets wet. Also, if it’s windy and rainy, your chances of igniting a fire with just one match are pretty slim. If it’s freezing cold, your BIC lighter (which uses butane) may not work at all.

Basically, starting a fire when it’s windy, cold and rainy is one of the worst situations imaginable, other than starting a fire under water, which is a skill only Chuck Norris masters (he uses phosphorus by the way).

I think I have already told you a dozen times in my previous articles about the holy trinity of survival, which includes fire as a means of providing you with (cooked) food, (safe) water and shelter (warmth, protection from wild animals etc), but also about the importance of location.

But do you know which survival essential is the first most important?

Find out how this little survival stove that fits in your pocket can save your life!

1. Find an Adequate Location for Making the Fire

Everything in life is location, as Van Helsing used to say back in the day, and the same mantra is true when it comes to making a fire.

The first thing to look for is an adequate location for making a fire in harsh weather conditions. The idea is to provide your fire with as much protection possible from both wind and rain if possible. And if you’re not in the middle of a frozen desert with no snow around, that’s not impossible.

Shelter means three basic things:

  • shelter from the wind
  • shelter from the rain
  • shelter from the ground water.

2. Shelter the Fire

Ideally, you should shelter your fire on more than one side (upwind).

Build a Windbreak

You can protect your fire by building a C shaped windbreak with the open side downwind. You can build a windbreak using wood, rocks, snow, dirt, just use your imagination.

To shelter your fire from the rain when outdoors is the hardest job, but it can be achieved.

Make the Fire Under a Tree

But pay attention! The easiest way is to make your fire under a tree, as evergreens can be regarded as a natural tent of sorts. All you have to do is to pick a big one and make your fire under the lowest branches.

Making a fire under a tree may not seem like the best idea, as there are inherent risks attached, like setting the tree on fire, but if you’re paying attention and keeping your fire under control, the chances of such an event happening are minor.

You can minimize the risks further by building a good fire pit with no combustible materials around the fire.

Build a Fire Pit

The third requirement is how to protect the fire from ground earth, with the previous two taken care of by now. The easiest method is to use rocks for building a fire pit on a spot where the ground is raised from the floor.

Or you can do that yourself, i.e. you can build a little mound and on top of the mound you’ll put a layer of rocks, thus preventing your fire from staying directly on the wet ground and also making sure any running water will be drained ASAP.

3. Tinder, Kindling and Fuel

So much for location folks, let’s move on to the next issue and I will start with an axiom: if you don’t have the Bear Grylls flame-thrower with you, starting a fire using wet wood is basically impossible and a no-go under any circumstances. You’ll waste your time and your gear, bet on a dead horse and the whole palaver.

Video first seen on CommonSenseOutdoors

However, there are ways, as Gandalf used to say, but ideally, you should try to find something dry for starting your fire. As a general rule of thumb, a fire gets started in 3 stages: tinder, kindling and fuel.

The tinder is a combustible material which is very easy to ignite, i.e. it will catch fire quick and easy.

The kindling can be improvised using pieces of finger-thick wood that will be lit from the kindle.

The rest is pretty straight forward, as far as your kindle gets ignited you’ll start the main fuel and you’ll have a fire burning in no time.

Two of the best survival-tinder (fire starters actually) which can be used for igniting a fire in adverse conditions (even with wet wood) are cotton balls soaked in petroleum jelly and dryer lint mixed with paraffin. These will burn for at least 2-3 minutes, thus providing you with plenty of time to get your fire started. I’ve already written an article about this issue.

As an interesting factoid, even in the midst of a rainstorm, you can almost surely find dried branches under the bottom of big/old pine trees. Another great place to look for dry combustible is the underside of uprooted (or dead) trees.

Video first seen on IA Woodsman

How to Make the Best Fire Starter for Wet Wood

The best fire-starter for wet wood can be home-made using black powder (gunpowder) and nail polish remover (the one that contains acetone). The acetone will be the solvent for the gunpowder. The idea is to make something that burns slow and as hot as possible and the gunpowder/acetone mix is by far the best in this regard.

Making the mix is fairly easy, as you’ll start with a small quantity of gunpowder the size of a golf ball put inside a ceramic/glass bowl. Start adding nail polish remover so that the mound of gunpowder is totally covered then mix it together slowly and thoroughly (always wear rubber gloves).

Once the stuff inside the ball gets in a putty-state, you can pour off the extra nail polish and then start kneading the putty, just like when making bread. i.e. folding it over time and time again.

The purpose of the kneading is to create layers inside your fire-starter. In this way, the burn rate is more controlled. The more layers, the better your fire-starter will be. The finished putty can be stored in an airtight container, but keep in mind that you’ll want to use your putty when it’s still moist. If dried, it burns too fast.

This fire-starter burns at 3000 degrees Fahrenheit and a golf-ball sized piece will burn for more than 3 minutes. Basically, you can set anything on fire with this baby and even  dry out damp wood in the worst conditions imaginable.

One final thing, it would always be nice to use fire accelerants, like gasoline (or alcohol, paint thinner etc), for starting a fire in rain or wind.

If you have your car around, the better, as you can siphon out some gasoline from the tank and start a fire even with damp wood in a jiffy. Okay, you’ll not receive those extra bonus style points, but that’s okay.

You’ll always have the peace of mind knowing that no matter where you go and no matter how bad the weather is you’ll be able to start a fire and safely cook food and boil some water. Click the banner below to grab this offer!

pocketstove_728x90_1

This article has been written by Chris Black for Survivopedia. 

Written by

Chris Black is a born and bred survivalist. He used to work as a contractor for an intelligence service but now he is retired and living off the grid, as humanly possible. An internet addict and a gun enthusiast, a libertarian with a soft spot for the bill of rights and the Constitution, a free market idealist, he doesn't seem very well adjusted for the modern world. You can send Chris a message at editor [at] survivopedia.com.

Latest comments
  • I have made and used cotton balls soaked with melted petroleum and they work well. A quick hint, they get packed together, so when you pull one out to use, tug on an edge or two and pull little pieces out and loose. They will catch much easier, like a wick. They also burn for 10 minutes each or so once they are lit. Good stuff!

  • I keep a small supply of Calcium Carbide in my bud out bag. Add water and a spark and Wa-la you have a fire starter. When you add water the material foams and acetylene gas is produced. I also use the petroleum jelly and cotton balls. Works great also.

  • This is great for that part of the world….however, if you live on Prairie…etc…it is much harder to even do this. Sooo, sometimes people get into accidents where there is little traffic. How do you get a fire started with grass, in a ditch, where many can wind up? Or in an area of cotton wood forest with willows…which is much harder to work with…any ideas on that kind of landscape? You don’t always have a tarp with you either. I do, but when hiking, many don’t. I did notice your clothes were also not water proof, so getting soaked and staying wet is a huge problem, which is anther difficult factor to deal with. So, any ideas and proper information for different areas that others live in like here in Alberta…with little wood, or with river habitat, flat prairie habitat etc. You have a forrest, which is VERY helpful for most…but would find it very difficult in our habitat. Anyway, thanks for the great tips! I liked the information on how to look for dry wood in so much rain. I also see that many who are informed about fires and survival (as in the show Alone) can have a really hard time getting it to burn in continued fashion that they need for hours on end…which is another hardship…getting enough fuel to keep it all going so you can also have shelter build time.. It can take HOURS to get rescued or even get out of an area if you get injured etc.

    • Well, in your situation, Vicki, you probably definitely want to have a mylar tube tent, waterproof sleeping bag, tarp, AND a small propane/fuel heater/cooker to keep you warm if you get stuck in remote prairie. Grass, if dried completely, will certainly burn, but it doesn’t last long. The minimum you’d have to do is bunch it up and twist it into a thick rope like bundle to get any burn time at all. But if there’s dry grass as far as the eye can see, well, it would be work, but at least you’d have fire?

  • I realize that there are always variables that cannot be taken into account in the limited space constraints of a short article, but the common one that kills a going campfire under a tree that wasn’t mentioned was starting a fire UNDER a large pine tree right after a blizzard, (which is the most likely time someone might get stranded and need to do it)

    A pine tree which is a widespread tree across the country in many winter climates has a tendency to capture a lot of snow in its branches after a blizzard.
    So much so that sometimes it weighs down the branches to where they bend downward changing the entire shape of the tree. It always looks like just the right cozy spot where you can lean up against the tree trunk or string out a tarp for cover but even a small campfire or a sudden heavy wind gust will eventually cause the snow even several feet above the branches to come down and douse your fire like Smokey the Bear with a fire extinguisher.

    • RE: “To Build a Fire”, by Jack London. Use a small/medium tree, get a stick, knock the snow off first! Tah-dah!

  • I make fire starters by opening the cover on a paper match book, soaking the matches with candle wax. Close the cover while the wax is warm. Fold out the cover or a couple of matches to light. I carry 4-5 in a siplock bag, w/ a regular book of matches (besides the other wooden matches I carry, etc.) Ever try those birthday candles that you can’t blow out? Light in a sheltered spot (behind you coat, hat or whatever), moving to the tinder, even if the wind ‘blows them out’, they will relight.

  • Plain old Styrofoam plus (pick one) acetone or nail polish remover, gasoline, kerosene or diesel, turpentine or other strong solvent. Add enough Styrofoam to the solvent to end up with a mixture the consistency of silly putty. Store in airtight and filled (no air space) containers. Sticky, really easy to light, and burns well and fairly long. Don’t breath the smoke from it.

    • Steve,
      You made a basic homemade version of napalm! Throw it against something and it will stick while burning.

  • “The best fire-starter for wet wood can be home-made using black powder (gunpowder) and nail polish remover (the one that contains acetone). The acetone will be the solvent for the gunpowder. The idea is to make something that burns slow and as hot as possible and the gunpowder/acetone mix is by far the best in this regard.”

    I was curious, how long would this mixture last if stored in a airtight, waterproof container?

LEAVE A COMMENT